In laboratory analysis, pharmaceutical compounding and electronics cleaning, the stability of ultrapure water often decides whether results are repeatable and whether yield holds. The traditional approach pairs two-stage reverse osmosis with mixed-bed ion exchange - but mixed beds require frequent acid and caustic regeneration, which adds operating cost and creates a waste stream that has to be treated.
HUAMO's cabinet-type RO + EDI system integrates pre-treatment, two-stage reverse osmosis and an EDI module inside a single stainless steel cabinet. Feed water goes in at one end and ultrapure water comes out at the other, in a footprint of roughly 1.5 m² (2 m² recommended with service clearance).
System configuration
The front end consists of quartz sand filtration, activated carbon filtration and resin softening, removing suspended solids, residual chlorine and hardness. The middle section is two-stage reverse osmosis, which takes out the bulk of dissolved salts. The final stage is an EDI module that performs continuous deep demineralisation. All wetted parts are SS304 stainless steel, and the compact cabinet suits installation close to the point of use in laboratories and production areas.
Key specifications
Capacity: 150 / 250 / 500 L/h
Product resistivity: ≥15 MΩ·cm (15–18 MΩ·cm in continuous operation)
Pre-treatment: quartz sand + activated carbon + softening
Core process: two-stage reverse osmosis + EDI
Control: PLC with touch screen, automatic operation, online conductivity and resistivity monitoring
Power supply: 380 V / 3 phase / 50 Hz (220 V available)
Cabinet material: SS304 stainless steel
Three practical advantages
First, no chemical regeneration. EDI removes ions continuously through an electric field combined with ion exchange resin, so there is no acid or caustic to handle - and no regeneration waste stream to dispose of.
Second, stable operation. Two-stage reverse osmosis provides EDI with qualified feed water, so the module runs consistently in the high-resistivity range. Water quality fluctuates very little, which reduces repeated experiments or product defects caused by unstable water.
Third, straightforward maintenance. The modular design allows cartridges, resin and the EDI module to be replaced individually. The control system displays conductivity and resistivity in real time and triggers an alarm and shutdown on abnormal conditions, protecting the module from dry running and damage.
Applications
Laboratory ultrapure water preparation, pharmaceutical process water, medical instrument rinsing, electronics and optical lens cleaning, cosmetic ingredient water, and small production lines with a defined resistivity requirement.
Supply and warranty
The system carries a 12-month warranty, with 24 months on the EDI module. We provide selection advice based on the customer's raw water analysis, together with a configuration list and process flow diagram. Standard models ship in 20–25 days.
Contact us for detailed configuration and pricing.





